导入骨骼数据后发现所有图片在同一位置

MADAO

Misaki

MADAO It is difficult to assess your situation based on screenshots alone. Please provide the version of the Spine Editor you are using, as well as the export and import steps you performed.

General information about importing skeleton data is summarized in the following blog post: Blog: 导入骨架数据

MADAO

Misaki

100111.atlas

16kB

100111.skel

732kB

editor version is 3.6.39

Misaki

MADAO There seem to be two points to pay attention to in order to obtain the correct result:

When unpacking this atlas, please use a newer version such as Spine 4.2. If you unpack it using version 3.6.53, the margins that should be present will not be restored correctly, resulting in misaligned coordinates. Also, please make sure to check the Unpremultiply alpha box when unpacking.
When importing the .skel file via Import Data..., please set the Scale to 0.5. Because the files were packed using an older version, the atlas file does not contain any scaling information, so I cannot determine exactly what scale the textures were packed at. However, based on my tests, importing them at a scale of 0.5 produced results that generally matched expectations.