Hi！
When I'm adjusting mesh using the mesh tool to enable soft selection and feathering, I tend to use a few recurring 'presets' for the parameters ( for example, size 30 with 60 feathering, size 50 with 100 percent feathering etc.). However, every time I have to drag the slider or manually input numbers to modify the mesh tool. It's a bit time consuming and the slider for size and feathering are also a bit hard to drag accurately.
It could be a good idea to have a preset panel in mesh tool view similar to the graph presets. So that the careful sliding or digits input can be replaced by an single click.
Thank you!
